A snow-covered two-story house photographed at night during a snowstorm, with a single illuminated window visible on the front façade.

HVAC Installation in Point Pleasant, NJ

A new system here will heat from October through May and cool from June through September every year. Tell us about the house, and a licensed contractor who covers Ocean County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An unfinished basement containing a gas furnace with ductwork in the foreground and miscellaneous stored items along the far concrete wall.

A system built for both ends of the year in Point Pleasant

Point Pleasant needs heat eight months a year, October through May, with winter nights averaging 27°F. Summer is shorter but still real, four months of afternoons averaging 84°F. Whatever gets installed has to carry both loads, not just the one you're thinking about today.

Most homes here heat with gas, and a new furnace has to hold up to a New Jersey winter, then hand off to the air conditioner for summer. Power is part of the picture too. Across New Jersey, 11% of households went at least 24 hours without power in 2024, and the region has logged 26 winter storms over the past ten years. Whoever installs your system should size and set it up with that in mind.

8 months
October through May, your system heats
4 months
June through September, it cools
27°F
the average winter night it heats against
84°F
the average summer afternoon it cools against
Isometric cutaway illustration of a single-story house showing interior rooms with furniture, ceiling ductwork, a furnace unit with a tall flue pipe, and a dark shingled roof.
Your system heats October through May and cools June through September.

NOAA nClimDiv, 1991–2020 normals

New Jersey requires HVAC contractors to hold a state license.

The license is held by the contractor, not issued per job, and it comes from the State Board of Examiners of Heating, Ventilating, Air Conditioning and Refrigeration Contractors. New Jersey towns cannot layer on their own HVAC license on top of that, so the same state credential applies whether the work is in Toms River or anywhere else in Ocean County.

For a new heating and cooling system, that state license is what stands behind the contractor's qualification to do the work. The part the license does not cover is the installation itself once it is in your house. That falls to the local building office, which in most towns requires a permit for a furnace, air conditioner or heat pump swap and sends someone out to inspect it when the job is finished.

Sources: New Jersey Legislature · New Jersey Division of Consumer Affairs

When should I replace my HVAC system?
Look at age and how often it breaks down. If a furnace or air conditioner needs a repair every season, it's usually costing you more than a new system would over time. Homes here run heat from October through May and cooling from June through September, so the system is working most of the year and wears accordingly. If your energy bills keep climbing while the house stays less comfortable, that's usually the system losing efficiency, not just an isolated problem.
Should I replace my furnace and air conditioner at the same time?
If both are old, yes, it usually makes sense to replace them together. A furnace and air conditioner installed at different times often end up mismatched, since new equipment is sized to work with the specific unit it pairs with, not just any unit that happens to be there. Replacing them at the same time also means one round of ductwork checks and one inspection instead of two. If only one has actually failed, a contractor can tell you whether the other is worth pairing it with or replacing now too.
What happens during an HVAC installation?
A contractor removes the old furnace and air conditioner or heat pump, then sets the new equipment and connects it to your ductwork, electrical, and for gas furnaces, the gas line. They check the ducts for leaks or sizing problems, since even a good furnace performs poorly if the ducts can't move enough air. Once everything is connected, they test the system and confirm it's heating or cooling the way it should. In most towns here, this work needs a permit from the local building office and an inspection when it's done, so the contractor should handle that as part of the job.